Networking: IP Address Classes (A, B, C, D, and E)

Networking · Last updated · About 2 min read

What Classful Addressing Was

Before CIDR (Classless Inter-Domain Routing) replaced it in 1993, IPv4 addresses were divided into five fixed "classes," identified by the value of an address's leading bits (in practice, its first octet). Each class fixed how many bits of the address were "network" vs. "host," which meant every network of a given class had exactly the same size, whether it needed it or not.

The Five Classes

Class First Octet Range Default Mask Network/Host Split Purpose
A 1–126 255.0.0.0 (/8) 8 bits network / 24 bits host Very large networks (~16 million hosts each)
B 128–191 255.255.0.0 (/16) 16 bits network / 16 bits host Mid-size networks (~65,000 hosts each)
C 192–223 255.255.255.0 (/24) 24 bits network / 8 bits host Small networks (254 hosts each)
D 224–239 n/a — not for hosts n/a Reserved for multicast group addresses
E 240–255 n/a — not for hosts n/a Reserved for experimental/research use

(127.x.x.x, technically inside the Class A range, is set aside for loopback addresses and was never actually usable as a Class A network.)

Why It's Still Worth Knowing

Classful addressing is obsolete for real-world routing and allocation, but the terminology persists in a few places worth recognizing: Class D's range (224.0.0.0–239.255.255.255) is still exactly the range IANA and routers actually use for multicast addresses today, so "Class D" survives as informal shorthand for "a multicast address" even though classful addressing itself is gone. Older documentation, training materials, and some legacy equipment configuration screens still reference class terminology even when the actual addressing in use is classless.

References

See also: CTI product documentation

This article is part of the CTI Products Knowledge Base. Questions about RadioPro or MCN products? Call +1 (513) 595-5900 or email info@ctiproducts.com.

Informational only. This article is general background and is not engineering, safety, legal or regulatory advice. Verify requirements with the equipment manufacturer and the applicable authority before relying on it. Product names and trademarks belong to their respective owners.