Comparators

MCN and BRSC Monitoring · Last updated · About 1 min read

This page is a deeper technical dive on comparator hardware specifically. See Voting Receivers and Comparators for the general overview of why voting exists and how remote receivers feed a comparator; this page focuses on how the comparator itself makes its voting decision.

The Core Job

A comparator receives simultaneous audio streams from multiple receivers (each hearing the same transmission from a different location) and must decide, often many times per second, which stream currently has the best quality — then forward only that stream onward, switching seamlessly between sources as conditions change during a single transmission.

What "Best" Actually Means

Signal strength (RSSI) alone is not a reliable measure of audio quality — a strong signal can still be noisy. Comparators instead typically combine multiple metrics:

  • A weighted combination of these (and similar) metrics is scored for each incoming receiver stream, and the comparator picks the highest-scoring one.

To avoid audible "chattering" between receivers when two streams have very similar quality, comparators generally require a challenger stream's score to beat the currently-selected stream's score by a minimum margin, and require the current stream to have been selected for at least a minimum hold time, before switching.

References

See also: CTI product documentation

This article is part of the CTI Products Knowledge Base. Questions about RadioPro or MCN products? Call +1 (513) 595-5900 or email info@ctiproducts.com.

Informational only. This article is general background and is not engineering, safety, legal or regulatory advice. Verify requirements with the equipment manufacturer and the applicable authority before relying on it. Product names and trademarks belong to their respective owners.