ACL (Access Control List)
What an ACL Is
An access control list (ACL) is a list of rules configured on a router, switch, or firewall that specifies which traffic is permitted or denied. Each rule (often called an access control entry) matches traffic against criteria such as source and/or destination IP address, source and/or destination port, and protocol (TCP, UDP, ICMP, etc.), and then either allows the traffic to pass or drops it. ACLs are evaluated in order from top to bottom, and most implementations apply an implicit "deny all" at the end of the list, so any traffic not explicitly matched and permitted by an earlier rule is dropped by default.
Two broad flavors are common in networking gear:
- Standard ACLs — filter only on source IP address, providing coarse control over an entire protocol/traffic set from a given source.
- Extended ACLs — filter on a more differentiated set of characteristics, including source and destination IP address, source/destination port numbers, and protocol, allowing much finer-grained rules (e.g., "allow only TCP port 443 from network A to host B").
ACLs can be applied to traffic in either direction on an interface (inbound or outbound), and when a router receives a packet on an interface with an inbound ACL applied, it checks the packet against the list's criteria in sequence: on a match, the configured action (permit or deny) is taken and evaluation stops for that packet.
Why ACLs Are Used
The core purpose of an ACL is network segmentation and security — restricting what traffic, and from where, is allowed to reach a given network, subnet, device, or service. Rather than leaving every device on a network reachable from anywhere, an ACL lets an administrator explicitly define the narrow set of legitimate traffic flows and drop everything else, which:
- Limits the attack surface of sensitive infrastructure by preventing unauthorized hosts or networks from even reaching it.
- Enforces trust boundaries between network zones (e.g., a trusted internal core vs. a less-trusted outside network).
- Provides a first line of defense that complements deeper packet inspection performed by dedicated firewalls (many modern routers and firewalls implement ACL-style rule matching as part of their firewall function, rather than as a wholly separate mechanism).
Related Pages
References
This article is part of the CTI Products Knowledge Base. Questions about RadioPro or MCN products? Call +1 (513) 595-5900 or email info@ctiproducts.com.
Informational only. This article is general background and is not engineering, safety, legal or regulatory advice. Verify requirements with the equipment manufacturer and the applicable authority before relying on it. Product names and trademarks belong to their respective owners.