GPS (Global Positioning System)

Two-Way Radio Concepts and Electronics Fundamentals · Last updated · About 4 min read

What GPS Provides Beyond Location

GPS is best known for positioning, but land mobile radio infrastructure relies just as heavily on the precise timing signal GPS satellites broadcast. Every GPS satellite carries an atomic clock, and receivers on the ground can extract an extremely accurate time reference from the satellite signals — accurate enough to synchronize equipment across widely separated sites without needing a shared physical cable.

GPS-Disciplined Oscillators (GPSDO)

A GPS-disciplined oscillator (GPSDO) combines a GPS receiver with a stable local oscillator (typically quartz or rubidium). The GPS receiver generates a highly accurate one-pulse-per-second (1PPS) timing reference from the satellite signal, and a tracking loop continuously steers the local oscillator to stay phase-aligned with that GPS-derived pulse. This gives equipment the short-term stability of a good local oscillator combined with the long-term accuracy of the GPS time standard — and critically, it lets multiple independent, geographically separated pieces of equipment (like radio transmitters at different repeater sites) all lock to the same time reference without a shared timing cable between them.

The Two LMR Uses of GPS

  1. Timing/synchronization — used by Simulcast systems so that transmitters at different sites can transmit identical audio on the same frequency at the same instant (see that page for the full explanation), and generally wherever RF equipment across multiple sites needs a common clock.
  2. Location tracking (AVL) — GPS receivers built into mobile/portable radios report the unit's coordinates back to a dispatch system for Automatic Vehicle Location (AVL), letting a dispatcher see where field units are on a map (see Dispatch Mapping Systems and Slippy Maps for how that position data gets rendered). This location data is one of the services the MNIS Data Gateway exposes to external applications in a MOTOTRBO Capacity Max system.

GPS Accuracy and Augmentation Systems

Standalone/unaugmented civilian GPS positioning is typically accurate to somewhere in the range of a few meters to a little over ten meters, depending on satellite geometry, signal obstruction (tall buildings, foliage, terrain), and receiver quality — good enough for most AVL/fleet-tracking purposes, but with real, variable error that matters for applications needing tighter precision (e.g., confirming a unit is on a specific side of a road, or precise geofencing at a facility boundary). Several augmentation systems exist specifically to improve on this baseline accuracy:

  • WAAS (Wide Area Augmentation System) — a network of FAA-operated ground reference stations across North America that measure small errors in the GPS satellites' signals, compute correction data, and broadcast those corrections via geostationary satellites to any WAAS-capable receiver at no additional cost. WAAS was originally built for aviation navigation (where it also adds integrity/reliability monitoring, not just accuracy), but any receiver with WAAS support benefits from it. Commonly cited accuracy improvements bring GPS positioning down to roughly 1–5 meters, though published figures vary by source and by real-world conditions.
  • DGPS (Differential GPS) — the older, more general concept WAAS is built on: a fixed ground reference station at a precisely known location compares its own GPS-computed position against its true surveyed position, computes the resulting error, and broadcasts a correction that nearby receivers (typically within some tens to a couple hundred miles of the reference station, depending on the specific DGPS network) can apply to their own readings. Commonly cited DGPS accuracy is on the order of 3–5 meters, similar to WAAS's typical improvement, though DGPS corrections are more localized to a specific reference station's service area rather than WAAS's wide-area, satellite-broadcast approach.
  • RTK (Real-Time Kinematic) — a much higher-precision augmentation technique (centimeter-level rather than meter-level) used in surveying and precision-agriculture applications; RTK requires more specialized/expensive receiver hardware and a nearby base station or correction network, and is generally beyond what typical LMR/AVL fleet-tracking equipment implements — mentioned here mainly to distinguish it from WAAS/DGPS rather than as a feature commonly found in two-way radio GPS receivers.

Practical relevance: whether a specific radio/AVL receiver actually supports WAAS or another augmentation system (and thus achieves better-than-baseline accuracy) is a per-product/per-radio specification, not something to assume — a "GPS position looks slightly off on the map" complaint is sometimes simply ordinary unaugmented GPS error within its normal expected range, not a malfunction, especially in dense urban canyons or heavy tree cover where signal multipath and obstruction degrade accuracy further regardless of augmentation.

References

See also: CTI product documentation

This article is part of the CTI Products Knowledge Base. Questions about RadioPro or MCN products? Call +1 (513) 595-5900 or email info@ctiproducts.com.

Informational only. This article is general background and is not engineering, safety, legal or regulatory advice. Verify requirements with the equipment manufacturer and the applicable authority before relying on it. Product names and trademarks belong to their respective owners.