Satellite Communications: Starlink

Two-Way Radio Concepts and Electronics Fundamentals · Last updated · About 3 min read

Overview

Starlink is a broadband internet satellite constellation and service operated by SpaceX.

Starlink instead delivers general-purpose internet connectivity — an IP pipe — to a user terminal, much like a cable or fiber modem would, and any voice, data, or radio-system traffic then rides on top of that IP connection. - Phased-array electronic beam steering instead of a parabolic dish. The Starlink user terminal ("Dishy") is a phased-array antenna containing roughly 1,280 individual antenna elements arranged in a hexagonal grid, controlled by RF chips on the antenna board. Rather than physically pointing a dish at a fixed satellite (as a VSAT dish does) or a slowly-moving one (as some MEO/LEO tracking systems do), the phased array electronically steers its beam to track fast-moving LEO satellites and hand off between them, with no moving parts required to aim the antenna.

Latency: Much Lower Than GEO

Because Starlink's satellites orbit at roughly 550 km rather than the ~35,786 km of a GEO satellite, round-trip signal travel time is drastically reduced:

  • Starlink (LEO): typical median latency in the roughly 25–50 ms range on land, with some measurements showing lows near 12–25 ms and increases to 80–100 ms during peak congestion hours or satellite handoff events.
  • Traditional GEO satellite service: round-trip latency of roughly 500-700 ms, consistent with the GEO latency figures already noted in Satellite Two-Way Radios.

This latency difference is the main practical reason Starlink can support applications — real-time voice, video, and interactive IP traffic — that are difficult or unusable over a traditional GEO link.

SpaceX offers a compact, portable terminal called Starlink Mini, relevant to mobile/rapid-deployment use cases:

  • Size and weight: approximately 298.5 × 259 × 38.5 mm, weighing about 1.1 kg without its kickstand.
  • Integrated design: the Mini integrates the phased-array antenna and a Wi-Fi 6 router into a single unit, and is built for rapid, tool-free deployment.
  • Power: draws roughly 25–40 W and accepts 12–48V DC input, making it practical to run from a vehicle or portable battery/solar setup rather than requiring a full AC power supply.
  • Environmental rating: IP67-rated, rated for operation across a wide temperature range and winds up to 60 mph, with an integrated snow-melt feature.
  • Performance: 100+ Mbps download speeds with latency around 23 ms reported in vendor/reviewer specifications.

Summary Comparison

Aspect Traditional Satellite Voice/Data (Iridium, VSAT) Starlink
Service type Purpose-built voice/data terminal General-purpose IP broadband service
Antenna Fixed-point or mechanically-tracking dish Electronically-steered phased array
Orbit GEO, MEO, or LEO LEO (~550 km)
Typical latency ~500 ms+ (GEO); lower for MEO/LEO ~25-50 ms typical
Primary LMR relevance Direct satellite voice/data for remote users IP backhaul for repeater sites; connectivity for mobile command posts

References

See also: CTI product documentation

This article is part of the CTI Products Knowledge Base. Questions about RadioPro or MCN products? Call +1 (513) 595-5900 or email info@ctiproducts.com.

Informational only. This article is general background and is not engineering, safety, legal or regulatory advice. Verify requirements with the equipment manufacturer and the applicable authority before relying on it. Product names and trademarks belong to their respective owners.