Digital Radio Audio Artifacts
The Root Cause: Vocoders Model Speech
Everything on this page follows from that: the vocoder is superb at one talker's speech and structurally bad at everything that isn't speech.
The Classic Artifacts
- Background noise gets mangled, not just carried. Sirens, chainsaws, pump/engine noise, alarms (including firefighter PASS alarms), and wind aren't speech, so the vocoder renders them as warbling, gurgling distortion — and worse, loud non-speech noise competes with the model, degrading the speech itself. On analog FM the same scene sounds noisy but the voice often stays intelligible; on digital, intelligibility can collapse. This is the documented core of fireground concerns about digital radio, and it's inherent, not a broken radio. Mitigations: noise-cancelling microphones/dual-mic suppression on modern radios, disciplined mic placement (close talk, shielded from the noise source), remote speaker mics positioned away from equipment noise. Artifact-then-silence at a repeatable location is a coverage issue, not an audio setting: treat via coverage troubleshooting.
- Everyone sounds slightly alike / flat. The vocoder reconstructs speech through its model, sanding off some individuality and tone — normal, and part of why voice recognition of who is talking is weaker than on analog (one reason PTT ID display matters more on digital systems).
- Delay. Vocoding + FEC + (on trunked systems) the channel grant add real end-to-end latency versus analog conventional. Users must respect the talk-permit tone or their first words are clipped — a top "digital radios cut off my first word" complaint that is user timing, not a defect (Common Radio Programming Parameters).
- Echo/doubling when analog and digital paths mix. Hearing the same transmission via an analog path and a digital path (patched systems, mixed-mode migrations, console + nearby radio) produces an offset echo because the digital leg arrives later — see Cross-Patching and System Bridging, which also covers the cumulative damage of vocoder tandeming (audio encoded/decoded through multiple vocoders in series).
Complaint → Interpretation Cheat Sheet
| User says | Most likely reality |
|---|---|
| "Sounds robotic/underwater in spot X" | Weak-signal FEC artifacts → coverage, not audio settings |
| "Can't understand me near running equipment" | Vocoder vs. non-speech noise → mic technique/noise-cancelling accessories; possibly analog fallback policy |
| "It cuts off the start of what I say" | Talking before the talk-permit tone |
| "Digital is quieter/duller than the old system" | Vocoder character + level-setting differences → verify levels (Audio Levels and Radio Interfacing) before blaming hardware |
| "Echo when dispatch talks" | Mixed analog/digital paths or patch delay |
| "It just drops — no static warning" | The digital cliff; that's how digital fails |
Policy Note
Some agencies deliberately keep analog conventional channels for high-noise close-range work (e.g., fireground) while using digital for wide-area operations — a legitimate engineering trade-off, not backwardness. Don't "correct" a customer for it; do make sure the choice is deliberate and documented in the fleetmap.
Related Pages
- Analog vs Digital Radio
- Audio Levels and Radio Interfacing
- Cross-Patching and System Bridging
- Troubleshooting Two-Way Radios
References
See also: CTI product documentation
This article is part of the CTI Products Knowledge Base. Questions about RadioPro or MCN products? Call +1 (513) 595-5900 or email info@ctiproducts.com.
Informational only. This article is general background and is not engineering, safety, legal or regulatory advice. Verify requirements with the equipment manufacturer and the applicable authority before relying on it. Product names and trademarks belong to their respective owners.