RadioPro IP Gateway RTP Streaming and Logging Recorder Interfaces
Two ways to record RadioPro radio traffic: analog audio to a logging recorder, or RTP packets with radio metadata sent to a recorder or incident-management system.
A RadioPro IP Gateway can hand its radio audio to an outside recording system in two ways. Neither replaces the built-in logging of RadioPro Dispatch.
Analog interface to a logging recorder
The Logging Recorder Interface document describes using the audio signals of a MOTOTRBO XPR 4550 or XPR 5550 control-station radio to feed a logging recorder. Two analog channels are needed on the recorder: one for transmit audio from the gateway and one for receive audio into the gateway. The radio is wired to the gateway through the interface cable, and a cable kit brings the audio pairs out to the recorder. The document gives a pin and wire-color table for the DE-9 connector (colors can differ with the cable, so they should be verified before connecting the recorder). It applies to software version 4 and higher and requires the current interface cable version.
RTP streaming
Gateways version 8.0.13 and later with the Voice Recording (RTP) license feature can stream audio, PTT IDs, GPS data and channel information to an incident-management or audio-recording application. In the ICU utility:
- Connect to the gateway (see radiopro-ip-gateway-installation-and-configuration).
- Open the Voice Recorder tab (it appears only when the gateway version and license allow it).
- Check Enabled.
- Enter a single destination IP address and port. RTP audio packets can be sent to one destination.
- Choose the audio encoding: G.722 at 8000 Hz, linear PCM at 8000 or 11025 Hz, or mu-law PCM at 8000 or 11025 Hz.
- Write the settings to the gateway.
Radio information in the RTP header
The gateway adds radio-specific data in the RTP header extension:
- Transmitting user: name (radio ID), type of user (0 = radio, 1 = group, 2 = PC), and GPS location (latitude, longitude, speed).
- Receiving user: the same three items.
- Gateway information: gateway name and channel information (zone and channel).
A PC user and a group user do not have GPS information.
August 2024 updates (gateway 8.1.27 and ICU 8.3.18)
- What is sent over RTP: Intercom is never sent; Rx audio is always sent; Tx audio is only the stream from the user who keyed the radio.
- The first RTP packet of each transmission is marked.
- Target frame sizes of 20 ms, 40 ms and 200 ms were added (default 200 ms), selectable in ICU's Voice Recorder tab, along with audio resampling improvements.
Source documents
This article summarizes the following published CTI Products manuals. They are the authoritative reference.
This article is part of the CTI Products Knowledge Base. Questions about RadioPro or MCN products? Call +1 (513) 595-5900 or email info@ctiproducts.com.
Informational only. This article is general background and is not engineering, safety, legal or regulatory advice. Verify requirements with the equipment manufacturer and the applicable authority before relying on it. Product names and trademarks belong to their respective owners.