Radio Frequency Basics

Two-Way Radio Concepts and Electronics Fundamentals · Last updated · About 5 min read

Understanding how two-way radios work starts with a few core concepts: frequency, Hertz, and wavelength. These fundamentals explain why some radios are better suited to wide-open rural areas while others perform better inside buildings and dense cities — a theme that runs through VHF Radios, UHF Radios, and 800/900 MHz Radios.

What Is Frequency?

Frequency is the number of radio waves that pass a fixed point in a given unit of time. It is measured in Hertz (Hz), where 1 Hz equals one wave cycle per second. Two-way radios typically operate in the millions of cycles per second, so their frequencies are expressed in megahertz (MHz) — for example, a radio operating at 154,000,000 Hz is described as operating at 154 MHz.

What Is Wavelength?

Wavelength is the physical distance between corresponding points of two consecutive waves (for example, from one wave crest to the next). Wavelength and frequency are directly linked by the speed of light, which is constant, so the two values move in opposite directions:

Land mobile radio bands and the range-versus-penetration trade-off A logarithmic frequency scale from 25 to 1000 megahertz marks the VHF low, VHF high, UHF, 700/800 and 900 megahertz land mobile bands, with the matching wavelengths from 10 metres down to 37 centimetres. Lower frequencies bend around obstacles and reach farther outdoors; higher frequencies travel in straighter lines and get into buildings. Two sine waves drawn to the same scale show a 150 megahertz wave with three cycles against a 450 megahertz wave with nine. The land mobile bands, and the trade-off across themFrequency rises to the right; wavelength shrinks as it doesVHF low30–50 MHzVHF high136–174 MHzUHF380–512 MHz700 / 800764–870 MHz900896–941 MHz3050150450900MHzWavelength λ = c / f10 m2 m67 cm33 cmlower: bends around hills, reaches farther outdoorshigher: travels straighter, gets into buildingsThe same stretch of space, two frequenciesThree times the frequency fits three times as many waves into it150 MHzλ = 2 m450 MHzλ = 0.67 m
Three times the frequency means one third of the wavelength. That single relationship is behind every band choice: 150 MHz for open ground, 450 MHz and above for buildings and cities.
  • Longer wavelength = lower frequency
  • Shorter wavelength = higher frequency

This inverse relationship is the single most important idea for predicting how a radio will behave in the field.

Calculating Wavelength from Frequency

Wavelength and frequency are related through the speed of light (c), since a radio wave is simply light-speed electromagnetic energy oscillating at a given rate:

Wavelength (λ) = Speed of light (c) / Frequency (f)

Using c ≈ 300,000,000 meters/second (or 186,000 miles/second ≈ 982,000,000 feet/second), this gives, for example:

  • 150 MHz → λ = 300,000,000 / 150,000,000 = 2 meters
  • 450 MHz → λ ≈ 0.67 meters (about 26 inches)

Why Lower Frequencies Travel Farther

Radio waves with longer wavelengths (lower frequencies) diffract, or bend, around obstacles more readily. This lets them follow the curvature of the earth and bend around hills and terrain to some degree, giving them a longer effective range outdoors — VHF signals can propagate somewhat beyond the visual horizon, out to roughly 160 km (100 miles) under favorable conditions. The tradeoff is that these longer waves do not penetrate dense materials like concrete walls, steel framing, or thick foliage very well.

Why Higher Frequencies Penetrate Buildings Better

Radio waves with shorter wavelengths (higher frequencies) travel more directly, in straighter lines, and reflect off — rather than bend around — obstacles. This gives them an advantage indoors and in cities: they punch through drywall, glass, and other building materials more effectively. The tradeoff is that they dissipate more quickly outdoors when there is no clear line of sight, since they cannot bend around terrain the way lower frequencies can, and repeated reflection off many surfaces without enough transmit power causes the signal to fade.

The AM vs. FM Analogy

This same principle is easy to observe in everyday broadcast radio:

  • AM radio broadcasts on much lower frequencies (0.525–1.705 MHz) and can travel hundreds of miles, especially at night, because its long wavelengths bend around terrain and follow the earth's curvature.
  • FM radio broadcasts on much higher frequencies (88–108 MHz) and typically fades into static after only 30–40 miles, because its shorter wavelengths travel in straighter lines and are more easily blocked by terrain and obstacles.

The same physics governs two-way radios: lower-frequency bands like VHF behave more like AM (longer range outdoors, weaker indoors), while higher-frequency bands like UHF behave more like FM (shorter outdoor range, better indoor/building penetration).

Power Density and the Inverse-Square Law

A transmitted signal's power spreads out as it travels away from the antenna, and the power density (power per unit area, e.g., watts per square inch or per square meter) drops off as the distance from the antenna increases. For a signal radiating outward in all directions, the same total transmitted power is spread over the surface of an ever-larger sphere (surface area A = 4πr²), so power density is inversely proportional to the square of the distance:

  • Double the distance from the antenna → power density drops to 1/4 of its previous value.
  • This is the same inverse-square law that governs light intensity, gravity, and other phenomena that radiate outward from a point source in three dimensions.

This is a basic physical reason why range and coverage fall off quickly with distance regardless of band, separate from the diffraction/penetration tradeoffs discussed above, and it's part of why every extra dB of antenna gain, transmitter power, or reduced feedline loss (see Repeaters and Antennas Basics) matters for extending usable range.

Regulatory Context: The FCC and 47 CFR

Two-way radio frequency use in the U.S. is governed by Title 47 of the Code of Federal Regulations (47 CFR), which covers the FCC and telecommunications generally. Radio operation normally requires an FCC license, with specific rules covering power limits, permitted uses (public safety, utilities, land mobile radio, cellular, radiolocation, and more), and whether a service is public or private, mobile or fixed.

Practical Takeaway

When choosing a two-way radio band, the question is really: where will this radio be used?

  • Open, flat, rural terrain with long sightlines favors lower frequencies — see VHF Radios.
  • Urban environments, buildings, and dense obstacles favor higher frequencies — see UHF Radios.

References

This article is part of the CTI Products Knowledge Base. Questions about RadioPro or MCN products? Call +1 (513) 595-5900 or email info@ctiproducts.com.

Informational only. This article is general background and is not engineering, safety, legal or regulatory advice. Verify requirements with the equipment manufacturer and the applicable authority before relying on it. Product names and trademarks belong to their respective owners.