Pre-Emphasis and De-Emphasis

Two-Way Radio Concepts and Electronics Fundamentals · Last updated · About 3 min read

What They Are

Pre-emphasis boosts the high audio frequencies in an FM transmitter before modulation; de-emphasis applies the mirror-image high-frequency cut in the receiver after demodulation. The two cancel exactly, so voice passes through sounding normal — but the noise the FM channel adds in between gets only the receiver's cut, not the transmitter's boost. The result is a substantially better signal-to-noise ratio, essentially free.

The reason it works: FM demodulation produces noise that rises with audio frequency (the "noise triangle") — FM noise is worst in the treble. Boosting treble before the channel and cutting it after means voice comes out flat while the channel's high-frequency noise is knocked down by the de-emphasis cut.

In two-way FM radio the standard curve is 6 dB per octave (a 750 µs-style time-constant family in LMR practice; broadcast FM uses 75 µs — the exact constant differs by service, the principle doesn't). Every conventional analog FM two-way radio applies these curves; it's baked in, not a menu option.

Flat vs. Emphasized Audio — Where It Bites

The concept turns practical the moment external equipment connects to a radio, because a radio has two kinds of audio points:

  • Mic input / speaker output — sit inside the emphasis chain (mic audio will get pre-emphasized; speaker audio has been de-emphasized). Sounds "normal."
  • Flat / line-level accessory points — bypass the emphasis network (direct modulator drive, discriminator output — "flat audio"). No curves applied.

Connect a console, tone remote, voter, or gateway to the wrong point and the audio arrives double-emphasized (harsh, hissy highs) or double-de-emphasized (muffled, muddy) — a classic install-day symptom documented from the interfacing side in Audio Levels and Radio Interfacing. Signaling suffers before voice does: CTCSS/DCS tones and data bursts like MDC-1200 are engineered for particular points in the chain (sub-audible tones are normally injected after pre-emphasis, directly at the modulator), and running them through an extra emphasis stage skews their levels — one reason tone-decode problems follow sloppy accessory wiring.

Digital Modes: Not Applicable (Mostly)

DMR, P25, and NXDN voice paths are digital — the vocoder bitstream modulates the carrier directly, and there is no analog emphasis chain to mismatch. Emphasis is an analog FM concept. It still matters on mixed systems: the analog channels of a mixed fleet, analog conventional repeaters, and any analog leg of a console/gateway path keep their curves, so a system that is "digital except for two analog channels" still has emphasis to get right on those two.

Symptoms Cheat-Sheet

Sound Likely emphasis fault
Harsh, spitty, exaggerated highs audio boosted twice (pre-emphasis applied to already-emphasized audio)
Muffled/muddy, weak highs audio cut twice (de-emphasis applied twice), or emphasized audio fed to a flat input
Voice OK but tones/data unreliable signaling injected at the wrong point in the emphasis chain

Diagnosis pairs naturally with a service monitor: transmit a tone sweep and watch whether the deviation-vs-frequency curve is flat or tilted where it shouldn't be.

References

  • TIA-603 (Land Mobile FM or PM Communications Equipment Measurement and Performance Standards) — the LMR measurement context for emphasis curves.

This article is part of the CTI Products Knowledge Base. Questions about RadioPro or MCN products? Call +1 (513) 595-5900 or email info@ctiproducts.com.

Informational only. This article is general background and is not engineering, safety, legal or regulatory advice. Verify requirements with the equipment manufacturer and the applicable authority before relying on it. Product names and trademarks belong to their respective owners.