RadioPro Dispatch Telemetry and Remote I/O (Tallysman Sprite and Advantech ADAM)

RadioPro and CTI Products · Last updated · About 3 min read

How the RadioPro Dispatch Telemetry panel monitors and controls vehicle and facility I/O using radio-based Tallysman modules and IP-based Advantech ADAM modules.

The Telemetry module of RadioPro Dispatch lets a dispatcher see the state of, and control, I/O points in vehicles and facilities from the same console that handles voice. The data sheet describes the two flavors as radio-based telemetry and IoT (Internet of Things).

Vehicle I/O: Tallysman Sprite modules

A Tallysman Sprite connects to a mobile radio. The installation guide lists:

  • 8 I/O points (3 inputs provided by the Sprite and 5 I/O provided by the radio);
  • store-and-forward of GPS and I/O data when the radio is out of RF coverage;
  • buffering and acknowledgements in the Sprite, so that control and status monitoring are reliable;
  • the TW200 model for MOTOTRBO and the TW202 for NEXEDGE.

The Sprite is configured with the manufacturer's Sprite Configuration Utility. Telemetry rides on the radio system's data path, so it depends on the radio system type (radiopro-dispatch-feature-availability-by-system-type, mototrbo-data-services).

Facility I/O: Advantech ADAM-6000 modules

Advantech ADAM-6000 series modules connect over IP to the Dispatch PC. They are compact and isolated. The guide recommends the ADAM-6050 (12 inputs, 6 outputs), ADAM-6052 (8 inputs, 8 outputs) and ADAM-6060 (8 inputs, 6 relay form-A outputs). Uses named in the data sheet include controlling and monitoring door access, monitoring temperature, pressure and voltage, and controlling actuators.

An unused module comes with a factory default IP address that has to be changed to the same subnet as the Dispatch PC using Advantech's configuration utility; after the general configuration the I/O channels are configured in the same tool.

Configuring Dispatch for telemetry

In Edit mode:

  1. Show the Telemetry panel (Show menu).
  2. Open Options, Dispatch Settings, and under Telemetry choose IO Module.
  3. Choose New Advantech, enter the module's IP address, choose its module type, and use Ping Module to confirm it responds.
  4. Under Pin Monitor & Control add digital pin controls and set them as preferred.
  5. Apply to save.

The Telemetry panel

The upper part lists each configured I/O point with a description and a color-coded status. Selecting one shows details in the lower part; for an output, the lower part acts as a button to change the state of the I/O point. Telemetry can also be assigned to custom actions and toolbar buttons (radiopro-dispatch-layout-gateways-and-licensing).

Driving an external signal from PTT

An external signal can be activated whenever any software or hardware PTT starts a call. The guide uses a USB dual-relay module with two Form-C relays between a USB port of the Dispatch PC and the equipment to be activated. The feature needs RadioPro Dispatch version 8.1.1 or later and no other configuration.

Source documents

This article summarizes the following published CTI Products manuals. They are the authoritative reference.

This article is part of the CTI Products Knowledge Base. Questions about RadioPro or MCN products? Call +1 (513) 595-5900 or email info@ctiproducts.com.

Informational only. This article is general background and is not engineering, safety, legal or regulatory advice. Verify requirements with the equipment manufacturer and the applicable authority before relying on it. Product names and trademarks belong to their respective owners.