Reverse Burst and Squelch Tail Elimination (STE)
Reverse burst (Motorola's term; generically squelch tail elimination, STE) is an end-of-transmission signaling trick in analog FM radio: just before dropping its carrier, the transmitter briefly shifts the phase of the CTCSS/PL tone, telling tone-squelch receivers to close immediately instead of waiting to notice the tone is gone. Its whole purpose is to eliminate the squelch tail — the burst of noise listeners otherwise hear between the moment a carrier drops and the moment squelch closes. This page covers the mechanism, decoder behavior, and — because it's a classic support puzzle — what happens when a reverse burst occurs in the middle of a transmission rather than at the end.
The Problem It Solves: the Squelch Tail
A CTCSS decoder is a very narrowband tone detector (tones ~67–254 Hz, spaced only a few Hz apart — see PL Tones, CTCSS & DCS). Narrowband detection is necessarily slow: reliably deciding "the tone is present" or "the tone has stopped" takes on the order of a few tenths of a second. So when a transmitter simply unkeys:
- The carrier disappears instantly, leaving open-squelch noise on the frequency.
- The tone decoder hasn't yet realized the tone stopped — squelch stays open.
- The listener hears a short, loud "kshhh" — the squelch tail — until the decoder catches up (or the carrier-drop detection closes squelch, depending on the radio's squelch logic).
The Fix: Shift the Tone's Phase at Unkey
With reverse burst/STE enabled, on PTT release the transmitter keeps transmitting for a short window (on the order of 150–200 ms) while sending the PL tone phase-shifted by a large angle before dropping carrier. The receiving decoder detects the abrupt phase discontinuity — something that never occurs in a legitimate continuous tone — and closes squelch immediately, while the carrier is still up. By the time the carrier actually drops, the receiver is already muted, so there is no audible tail.
Implementation details vary by vendor and era — Motorola's classic Reverse Burst and other vendors' STE implementations use different phase-shift angles (figures in the 120°–240° range appear across implementations; see the note at the bottom of this page), and TIA-603 standardizes the general turn-off behavior. DCS has an equivalent mechanism: at end of transmission a DCS radio stops the code and transmits a brief turn-off tone (commonly cited as ~134 Hz) that tells DCS decoders to close.
Both ends must cooperate: a transmitter sending reverse burst benefits only receivers whose decoders implement phase-reversal detection; a receiver without it simply falls back to the slower tone-absence detection (and still hears a tail). A receiver in carrier squelch (CSQ) ignores tones entirely — reverse burst does nothing for or to it; its tail behavior is governed purely by carrier/noise squelch speed.
Related Pages
- PL Tones, CTCSS & DCS
- Squelch Types
- Common Radio Programming Parameters
- Voting Receivers and Comparators
- Repeaters and Antennas Basics
References
- TIA/EIA-603 (Land Mobile FM or PM Communications Equipment Measurement and Performance Standards) — standardizes tone-squelch turn-off behavior.
This article is part of the CTI Products Knowledge Base. Questions about RadioPro or MCN products? Call +1 (513) 595-5900 or email info@ctiproducts.com.
Informational only. This article is general background and is not engineering, safety, legal or regulatory advice. Verify requirements with the equipment manufacturer and the applicable authority before relying on it. Product names and trademarks belong to their respective owners.