Control-Station Radios Supported by RadioPro: MOTOTRBO, APX 4500 and NEXEDGE Models
Which Motorola and Kenwood radios can serve as RadioPro control stations, what each provides, minimum firmware and the rules for sharing a gateway.
A control-station radio is the radio that a RadioPro IP Gateway connects to its rear accessory or communications port. One gateway is needed for each control-station radio used for voice. For general information about control stations see control-stations.
Supported models
| Maker and system | Models | Programming software | Notes |
|---|---|---|---|
| Motorola MOTOTRBO | XPR 2500, XPR 5350, XPR 5550, XPR 5550e | CPS | Full radio functionality from a RadioPro client. The XPR 2500 has no GPS, so it cannot be used for data revert. The guides also refer to the XPR 4550. See radiopro-ip-gateway-with-motorola-mototrbo |
| Motorola P25 | APX 4500 | CPS (Motorola cable) | Intercom interface, voice only with no PTT ID, and no GPS. See radiopro-ip-gateway-with-motorola-apx-4500 |
| Kenwood NEXEDGE | NX-700/800, NX-720/820, NX-3720/3820, NX-5700/5800 | KPG-111DN or KPG-D1N FPU | See radiopro-ip-gateway-with-kenwood-nexedge |
The family-of-products brochure and the data sheets state that Motorola control stations should be supplied by a Motorola-authorized two-way radio dealer and Kenwood radios by Kenwood-authorized dealers; the dispatch PC, microphone, PTT accessories and desk speakers are supplied by the dealer or end user (radiopro-microphones-and-ptt-accessories).
Minimum firmware
| Radio | Minimum version |
|---|---|
| MOTOTRBO in Conventional, IP Site Connect, Capacity Plus or Linked Capacity Plus | 1.08.0 |
| MOTOTRBO in Connect Plus mode | 2.2.0 |
| MOTOTRBO Connect Plus option board | 1.3.0 |
| Kenwood NX-700/800 or NX-720/820 | 3.21.00 (KPG-111DN) |
| Kenwood NX-5700/5800 | 2.31.00 (KPG-D1N) |
| Kenwood NX-800 (Dispatch guide) | 1.23.00 |
Rules and cautions
- Radios that share an IP Gateway (a voice radio plus up to three data revert radios) must have the same Radio ID, be on different subnets, and the voice radio's IP address must be lower (radiopro-system-planning-for-mototrbo).
- A programming cable on the front microphone connector prevents communication through the rear accessory connector; the two cannot be used at the same time.
- Mounting: the radio and gateway can sit side by side on one 19-inch rack shelf of at least 12 inches depth.
- For feature support by system type, see radiopro-dispatch-feature-availability-by-system-type.
- Antenna distance: keep mobile radio antennas at least 24 feet from the gateway at high power (12 feet at low power), and portables at least 6 feet.
Source documents
This article summarizes the following published CTI Products manuals. They are the authoritative reference.
This article is part of the CTI Products Knowledge Base. Questions about RadioPro or MCN products? Call +1 (513) 595-5900 or email info@ctiproducts.com.
Informational only. This article is general background and is not engineering, safety, legal or regulatory advice. Verify requirements with the equipment manufacturer and the applicable authority before relying on it. Product names and trademarks belong to their respective owners.